Legrand RFB2 Bedienungsanleitung PDF herunterladen (Seite 3)

WOOD FLOOR INSTALLATION:

Step 1. Determine box location and orientation.

Step 2. Cut a 6" [152mm] x 7 1/4" [184mm] opening in

wood floor.

Step 3. Remove box cover and desired knockouts. Attach

appropriate connectors per wiring type (mc cable,

conduit, nonmetallic, sheathed, etc., not supplied

by Wiremold) to steel base. Remove tunnel block(s)

as required if power is to be used on both sides of

the box.

Step 4. Re-attach cover to box with two (2) #8-32 x 1/2" long

screws provided.

Step 5. Align plastic trim ring on top of box with opening in

floor, and secure box to underside of floor with four (4)

#8 or four (4) #10 pan head sheet metal screws, (not

supplied by Wiremold), through the four (4) holes

provided in cover.

Step 6. Wire devices, (not supplied by Wiremold), making sure

that any ground leads are properly connected to

ground screws. Attach the receptacle to the

receptacle mounting bracket using the #6-32 screw

provided. Secure the receptacle to the receptacle

mounting bracket with two (2) additional screws and

nuts, (not provided). Attach the receptacle mounting

bracket(s) to the base with the two (2) #8-32 mounting

screws provided.

Step 7. Complete procedure by installing a Wiremold

FloorPort Activation, (sold separately), using the

installation instructions provided with that unit.

NOTE: Box is supplied with tunnel bracket, tunnel blocks

and device mounting brackets installed. If the

same service is to be used in both compartments,

it will be necessary to remove one or both of the

tunnel blocks to allow for pass through of the

service wiring. The tunnel blocks are accessible by

removing the tunnel support. The installer may do

this either pre- or post-installation.

NOTE: Use insulator provided with the following catalog

numbers, installed as shown: RFB2DP, RFB2GFI.

Tunnel Blocks

Tunnel Support

1 2 3 4

Keine Kommentare

Legrand RFB2 Bedienungsanleitung Seite 3