Legrand CS Series 360° PIR Bedienungsanleitung PDF herunterladen (Seite 6)

SENSOR ADJUSTMENT

The sensor comes factory preset and ready for operation.

If testing of operation is desired:

• Remove the sensor’s cover (twist).

• Refer to the DIP switch settings chart below for switch configurations.

• Make sure that office furniture and fixtures are in place.

1. Restore power to the lighting circuits and turn the lights on.

• There is a one minute warm-up when power is initially restored to the

sensor before the sensor works properly.

2. Set Time Delay to minimum: DIP switches #1 through 6 set to ON

(15 secs.).

3. Set Sensitivity to maximum: DIP switches

#7 and #8 to ON.

4. Replace the sensor’s cover.

5. Move away from sensor and be still.

The lights should go off after 15 seconds.

Note: If lights remain on, move farther away or out of sight of the sensor.

If lights still remain on, set the Sensitivity to medium high by setting DIP

switches #7 to ON and #8 to OFF, or see Unwanted Sensor Activations

under Troubleshooting.

6. Set the appropriate Time Delay (DIP switches #1 through 6).

The factory preset Time Delay is 18 minutes; other suggestions are:

Offices and conference rooms: 10 minutes.

Classrooms: 10 minutes.

Warehouses: 6 minutes.

Hallways: 4 minutes.

DIP SWITCH SETTINGS

LED

IP Switch Control

or Time Delay and

ensitivity

DIP Switch #

15 seconds

4 minutes

6 minutes

8 minutes

10 minutes

12 minutes

14 minutes

16 minutes

18 minutes

20 minutes

22 minutes

24 minutes

26 minutes

28 minutes

2 minutes

Minimum

Medium Low

Medium High

Maximum

1234 78

SensitivitySensitivity

30 minutes

= ON

– = OFF

= Factory Presets

1 2 3 4 5 6 7 8

Kommentare zu diesen Handbüchern

Keine Kommentare

Legrand CS Series 360° PIR Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Legrand CS Series 360° PIR