Legrand RC4KTCBK Bedienungsanleitung PDF herunterladen

IMPORTANT – PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING.

Products Covered: RC4KTC

CAUTION: Do Not operate tile stripper or resurfacing equipment over top of covers. This may result in damage to the surface finish of the product.

Step 1. Disconnect receptacle wiring in junction box. Step 2. Remove two screws and slide holder.

CAUTION: De-energize circuit before removing junction box cover.

Step 3. Remove six screws and trim ring. Step 4. Pull receptacles and receptacle brackets

out of Poke-Thru device.

RC4 Replacement Scrub Water

Cover Assembly Kit

INSTALLATION INSTRUCTIONS

Installation Instruction No.: 1 002 139 R1 – Updated October 2003

Screws

Slide Holder

Screws

Trim Ring

Walker

electrical systems conform to and should be properly grounded

in compliance with requirements of the current National Electrical Code

or codes administered by local authorities.

All electrical products may present a possible shock or fire hazard if

improperly installed or used. Walker electrical products may bear the

mark as UL Listed and/or Classified and should be installed in

conformance with current local and/or the National Electrical Code.

1 2 3 4

IMPORTANT – PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING.Products Covered: RC4KTC CAUTION: Do Not operate tile stripper or resurfacing equipment ove

Step 5. Guide replacement receptacle brackets into Step 6. Attach trim ring to bracket with four screws place. Direct wire leads through indicated p

Step 9. Make electrical connections in junction box Step 10. Wiring Diagram. Connect receptacle leads according to wiring diagram. to branch circui

Seite 4

The RC4TC Series Poke-Thru Device is UL Listed and Classified to U.S. and Canadian safety standards to the following conditions: The RC4STC Poke-Thru

Verwandte Modelle: RC4KTCGY | RC4KTCVY | RC4KTCAL | RC4KTCBS | RC4KTCAB |

Keine Kommentare