Legrand WC PK Preset Activation Kit Bedienungsanleitung PDF herunterladen

Products Covered: WPACR, PKGRBR, and DTB Communication Brackets

Preset Location:

1. Determine location of preset cover by measuring (when layout is known)

or by using an electronic preset finder.

2. Cut or remove floor covering over preset location.

3. Using a hammer, remove the concrete from mudcap cover.

4. Remove the mudcap by hitting the center of the cap until the sides are deformed.

5. Insert a screwdriver along the edge of the cap and pry up.

6. Remove any debris that may have fallen into the preset opening.

Power Installation:

1. Remove knockout from power compartment. Grommets must be installed prior

to pulling cables and before internal components are installed to prevent damage

to cables.

2. Place one side of the two-piece grommet over the power opening and squeeze

until it snaps into place. Repeat for the other piece of the grommet.

3. Install the second set of grommets if activating both sides of the preset with power.

4. Pull the electrical wires through the grommeted openings in the center cell.

5. Attach electrical conductors to the UL Listed duplex receptacle(s).

Make sure that any ground leads are connected to ground screws.

6. Attach the receptacle insulator and receptacle to the receptacle mounting bracket

using #6 screw provided. Attach the receptacle to the receptacle mounting bracket

with two additional screws and nuts (not provided). Attach the outlet box cover to

the preset using two #10 mounting screws provided.

PK Preset Activation Kit

I N S T A L L A T I O N I N S T R U C T I O N S

Installation Instruction No.: 1 002 300R1 – Updated March 2010

Wiremold electrical systems conform to and should be properly

grounded in compliance with requirements of the current National

Electrical Code or codes administered by local authorities.

All electrical products may present a possible shock or fire

hazard if improperly installed or used. Wiremold electrical products

may bear the mark as UL Listed and/or Classified and should

be installed in conformance with current local and/or the National

Electrical Code.

IMPORTANT: Please read all instructions

before beginning.

1 2

Inhaltsverzeichnis

Seite 1 - PK Preset Activation Kit

Products Covered: WPACR, PKGRBR, and DTB Communication Brackets Preset Location: 1. Determine location of preset cover by measuring (when layout is k

Seite 2 - Communication Installation:

Communication Installation: 1. Align communication grommet so the letters “FRONT” are facing toward you. NOTE: Do not install grommets if using commun

Kommentare zu diesen Handbüchern

Keine Kommentare

Legrand WC PK Preset Activation Kit Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Hardware Legrand WC PK Preset Activation Kit herunter. Legrand WC PK Preset Activation Kit User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Legrand WC PK Preset Activation Kit