Legrand RC7KTC Bedienungsanleitung PDF herunterladen

IMPORTANT – PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING.

Products Covered: RC7KTC

CAUTION: Do Not operate tile stripper or resurfacing equipment over top of covers.

This may result in damage to the surface finish of the product.

Step 1. Remove junction box cover and disconnect wires. Step 2. Remove slide holder and receptacle.

Lift out receptacle and attached conductors.

CAUTION: De-energize circuit before removing junction box cover.

Step 3. Release tabs on communication jacks Step 4. Remove four #6-32 flange screws and detach

and lift out. Cut terminations. Existing existing flange. Remove two #8-32 screws

communication jacks and adapters will from plastic receptacle shell and discard.

not mount in RC7ATC flange.

RC7

Replacement Scrub Water

Cover Assembly Kit

INSTALLATION INSTRUCTIONS

Installation Instruction No.: 1 002 151 R1 – Updated October 2003

Walker

electrical systems conform to and should be properly grounded

in compliance with requirements of the current National Electrical Code

or codes administered by local authorities.

All electrical products may present a possible shock or fire hazard if

improperly installed or used. Walker electrical products may bear the

mark as UL Listed and/or Classified and should be installed in

conformance with current local and/or the National Electrical Code.

1 2 3 4 5 6

Inhaltsverzeichnis

Seite 1 - Cover Assembly Kit

IMPORTANT – PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING. Products Covered: RC7KTC CAUTION: Do Not operate tile stripper or resurfacing equipment o

Seite 2 - Wiring Label

2Step 5. Cut existing carpet to 6 1/2" [165mm] Step 6. Install new receptacle barrier with two #8-32diameter surrounding existing hole. screws t

Seite 3

3Step 8. If circuit is connected to an isolated ground, apply IG icon on receptacle slide as shown. NOTE: The orange triangle shall only be placed on

Seite 4

4Step 11. Snap communication jacks or communication port plugs into flange. Step 12. Align gasket over receptacle and press bead into flange channel.C

Seite 5

5The RC7TC Series Poke-Thru Device is UL Listed and Classified to U.S. and Canadian safety standards to the following conditions: The RC7STC Poke-Thru

Seite 6 - CARPET CUTOUT TEMPLATE

The Wiremold Company U.S. and International: 60 Woodlawn Street • West Hartford, CT 061101-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-2

Verwandte Modelle: RC7KTCAB | RC7KTCAL | RC7KTCBK | RC7KTCBS | RC7KTCGY | RC7KTCVY |

Kommentare zu diesen Handbüchern

Keine Kommentare

Legrand RC7KTC Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Hardware Legrand RC7KTC herunter. Legrand RC7KTC User Manual Benutzerhandbuch

Inhaltsverzeichnis

Verwandte Modelle: RC7KTCAB | RC7KTCAL | RC7KTCBK | RC7KTCBS | RC7KTCGY | RC7KTCVY |

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Legrand RC7KTC